LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Manual Transmission - ZF S6-650 - Service, Troubleshooting & Diagnosis) >> Repair Instructions >> Transmission Input Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the NEW seal in the front case with the part number facing out.
    Fig 1: Positioning New Seal In Front Case
    GM694468Courtesy of GENERAL MOTORS CORP.
  2. Using J 44731  install the input shaft seal. See Special Tools .
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 2: Removing Clutch Actuator Cylinder
    GM689675Courtesy of GENERAL MOTORS CORP.
  3. Position the clutch actuator cylinder.
  4. Install the clutch actuator cylinder bolts.

    Tighten:  Tighten the bolts to 8 N.m (71 lb in).

  5. Install the transmission. Refer to Transmission Replacement .
  6. Install the rear propeller shaft. Refer to Propeller Shaft Replacement - One Piece or Propeller Shaft Replacement - Two Piece in Propeller Shaft.
  7. Check the transmission fluid level. Add if necessary.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals