LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Manual Transmission - ZF S6-650 - Service, Troubleshooting & Diagnosis) >> Repair Instructions >> Shift Lever Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install a NEW shift lever insulator, if required.
  2. Apply gasket maker GM P/N 12378517 or equivalent to the surface of the control lever assembly.
  3. Push the shift lever assembly back through the insulator, position and turn the shift lever assembly back into place.
  4. With a flat tool pull back the insulator between the body and transmission to install the shift lever assembly bolts.
    Fig 1: Accessing Shift Tower Bolts
    GM691688Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the shift lever assembly bolts.

    Tighten:  Tighten the bolts to 23 N.m (17 lb ft).

  6. Install the control lever and boot. Refer to Control Lever and/or Boot Replacement .
scientia non olet · About LEMON Manuals