LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Manual Transmission - ZF S6-650 - Service, Troubleshooting & Diagnosis) >> Repair Instructions >> Control Lever and/or Boot Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the control lever.
    Fig 1: Removing Control Lever
    GM772338Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Loosen DO NOT remove the shift lever assembly adjustment nut if replacing the control lever.
  2. Remove the control lever boot retainer plastic retainers, if necessary.
    Fig 2: Removing Control Lever Boot Retainer Plastic Retainers
    GM772340Courtesy of GENERAL MOTORS CORP.
  3. Remove the control lever boot retainer, if necessary.
  4. Remove the control lever boot screws, if necessary.
    Fig 3: Removing Control Lever Boot Retainer
    GM772341Courtesy of GENERAL MOTORS CORP.
  5. Remove the control lever boot, if necessary.
  6. Remove the control lever insulator, if necessary.