Installation Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Fig 1: Installing Backup Lamp Switch

Courtesy of GENERAL MOTORS CORP.

Install the backup lamp switch.
Tighten: Tighten the switch to 20 N.m (15 lb ft).
If equipped with a 8.1L engine, connect the backup lamp switch electrical connector (4).

Fig 2: Connecting Backup Lamp Switch Electrical Connector (8.1L Engine)
Courtesy of GENERAL MOTORS CORP.
If equipped with a 6.6L engine, connect the backup lamp switch electrical connector (3).

Fig 3: Connecting Backup Lamp Switch Electrical Connector (6.6L Engine)
Courtesy of GENERAL MOTORS CORP.

Lower the vehicle.