Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Coat the NEW O-ring seal with a thin film of transmission fluid, use GM P/N 12346190 (Canadian P/N 10953477), or equivalent.

Fig 1: Installing VSS And Seal
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .
Install the VSS.
Tighten: Tighten the VSS to 16 N.m (12 lb ft).
Connect the VSS electrical connector (3).

Fig 2: Connecting Vehicle Speed Sensor (VSS) Electrical Connector
Courtesy of GENERAL MOTORS CORP.

Lower the vehicle.