Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Position the transmission mount.
NOTE: Refer to FASTENER NOTICE .
Install the transmission mount to transmission bolts.

Fig 1: Installing Transmission Mount Bolts
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the transmission mount bolts to 50 N.m (37 lb ft).
Lower the transmission and remove the transmission jack.
Install the transmission mount to crossmember nut.

Fig 2: Installing Transmission Mount To Crossmember Nut
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the transmission mount to crossmember nut to 40 N.m (30 lb ft).
Lower the vehicle.