Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Apply a thin bead of sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent to the oil drain and fill plug threads.
NOTE: Refer to FASTENER NOTICE .
Install the oil drain plug.

Fig 1: Installing Oil Drain Plug
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the plug to 37 N.m (27 lb ft).
Fill the transmission to just below the bottom of the fill plug hole. Refer to Lubrication Specifications .

Fig 2: Filling Transmission To Just Below Bottom Of Fill Plug Hole
Courtesy of GENERAL MOTORS CORP.
Install the oil fill plug.

Fig 3: Installing Oil Fill Plug
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the plug to 37 N.m (27 lb ft).
Lower the vehicle.