LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Manual Transmission - NV 4500 - Service) >> Repair Instructions >> Backup Lamp Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Ensure the seal is installed on the switch.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the backup lamp switch.
    Fig 1: Installing Backup Lamp Switch
    GM761120Courtesy of GENERAL MOTORS CORP.

    Tighten:  Tighten the switch to 28 N.m (21 lb ft).

  3. Connect the backup lamp switch electrical connector (1).
    Fig 2: Connecting Backup Lamp Switch Electrical Connector
    GM775031Courtesy of GENERAL MOTORS CORP.
  4. Lower the vehicle.