Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Position transmission mount.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install transmission mount to transmission bolts.

Fig 1: Installing Transmission Mount Bolts
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten transmission mount bolts to 50 N.m (37 lb ft).
Lower transmission and remove transmission jack.
Install transmission mount to crossmember nut.

Fig 2: Installing Transmission Mount To Crossmember Nut
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten transmission mount to crossmember nut to 40 N.m (30 lb ft).
Lower vehicle.