LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Manual Transmission - NV 3500 - Service) >> Repair Instructions >> Shift Lever Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install a NEW shift lever insulator.
  2. Install shift lever seal and lever.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install shift lever bolts.

    Tighten:  Tighten bolts to 20 N.m (15 lb ft).

  4. Install boot.
  5. Install control lever and boot. Refer to Control Lever and/or Boot Replacement .
    Fig 1: Installing Control Lever And Boot
    GM772342Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals