LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission Clutch System) >> Repair Instructions >> Release Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: DO NOT use cleaners or chemicals to clean the quill and DO NOT grease the quill.
  1. Using a clean dry cloth, clean the exposed area of the actuator cylinder quill.
  2. Install the NEW clutch release bearing to the clutch actuator cylinder.
    Fig 1: Installing Clutch Release Bearing
    GM71485Courtesy of GENERAL MOTORS CORP.
    • Firmly push the clutch release bearing into place.
    • The release bearing will snap over the retainer tab and will be self-retained to the actuator cylinder.
  3. Install the manual transmission. Refer to:
scientia non olet · About LEMON Manuals