LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission Clutch System) >> Repair Instructions >> Pilot Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: When using the J 43276 Clutch Pilot Bearing Remover, always secure the J 43276-1 Clutch Pilot Bearing Remover tool body using a wrench. Do not allow the J 43276-1 tool body to rotate. Failing to do so causes damage to the J 43276-1 tool body.
IMPORTANT: The flywheel spacer (if applicable) must be removed prior to clutch pilot bearing removal.
  1. Remove the clutch assembly. Refer to Clutch Assembly Replacement .
  2. Using J 43276  perform the following in order to remove the clutch pilot bearing:
    1. Install the J 43276-1 into the clutch pilot bearing.
    2. Using a wrench, secure the J 43276-1.
    3. Insert the J 43276-2 into the J 43276-1.
    4. Rotate the J 43276-2 clockwise into the J 43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
    5. Rotate the J 43276-2 counterclockwise to remove the J 43276-2 from the J 43276-1.
    6. Remove the J 43276-1 from the tool body.
      7. Fig 1: Removing Clutch Pilot Bearing Using J 43276
      GM353275Courtesy of GENERAL MOTORS CORP.
  3. Discard the old clutch pilot bearing.
    Fig 2: View Of Pilot Bearing (without RPO HP2)
    GM642283Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals