Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Align the tabs on the new wiring harness U-channel with the solenoid retainer slots for SS3 (3) and SS2 (2) on the control valve assembly. Install the solenoid retainers (12) for the SS3 (3) and SS2 (2) solenoids.
- Attach the internal wiring harness connectors to the solenoids, the IMS, and the TFP switch.
- Connector (8) goes to SS 1 (5)
- Connector (9) goes to the TFP switch (7)
- Connector (11) goes to the MAIN MOD solenoid (19)
- Connector (10) goes to solenoid (2)
- Connector (13) goes to the IMS
- Connector (14) goes to the TCC PCS (1)
- Connector (15) goes to SS2 (2)
- Connector (16) goes to SS 3 (3)
- Connector (17) goes to PCS 1 (4)
- Connector (18) goes to PCS 2 (6)
- Push the main transmission connector (2) outward through hole (1) in the transmission case until the retaining feet on the connector are near the locked position.
- Use J 44247 to seat the retaining feet on transmission connector (1). See Special Tools .
- Install the oil pan and transmission internal oil filter. Refer to Oil Pan Replacement .
- Connect the external wiring harness to the main transmission connector.
IMPORTANT:
The internal wiring harness connectors should be in the correct position for installation because of their pre-assembled position in the U-channel.