LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Automatic Transmission - ALLISON - Introduction (2 Of 2)) >> Repair Instructions >> Transmission Fluid Cooler Connector Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Transmission Oil Cooler Pipe Connectors
    GM659002Courtesy of GENERAL MOTORS CORP.
  1. Install new transmission oil cooler pipe connectors (1) and (2).

    Tighten:  Tighten to 25 N.m (18 lb ft).

  2. Connect the hose to the transmission oil cooler pipe connectors.
scientia non olet · About LEMON Manuals