Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Connect the TCM electrical connectors (2) to the TCM.
- Install the TCM to the cover.
- Using the alignment tabs (1), install the cover and module to the radiator shroud.
- Install the TCM cover bolts (1) to the radiator shroud.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
- Reprogram the TCM. Refer to Control Module References in Computer/Integrating Systems.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.