LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Automatic Transmission - ALLISON - Introduction (2 Of 2)) >> Repair Instructions >> Torque Converter Housing Bolt Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install new seals on any bolts (1) removed.
    Fig 1: Torque Converter Housing Bolts
    GM659006Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install any bolts (1) removed.

    Tighten:  Tighten bolts to 56 N.m (41 lb ft).

  3. Install the torque converter into the transmission. Refer to Torque Converter Replacement .
scientia non olet · About LEMON Manuals