LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Automatic Transmission - ALLISON - Introduction (2 Of 2)) >> Repair Instructions >> Seal Replacement - Torque Converter >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing Torque Converter Seal Using J 24171-A
    GM659305Courtesy of GENERAL MOTORS CORP.
  1. Remove the torque converter from the transmission. Refer to Torque Converter Replacement .
  2. Obtain J 24171-A  and install the tip (3) with a 90 degree hook onto the end of the slide-hammer (1). See Special Tools .
  3. Position the 90 degree hook behind the rear face of the seal outer case (2). Remove the torque converter seal using the slide-hammer.
  4. Inspect the seal bore for scratches. Remove any scratches in the seal bore using crocus cloth.
scientia non olet · About LEMON Manuals