LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Automatic Transmission - ALLISON - Introduction (2 Of 2)) >> Repair Instructions >> Pressure Switch Manifold Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 1: Installing TFP Switch
    GM1633282Courtesy of GENERAL MOTORS CORP.
  1. Place the new TFP manifold assembly (2) in position and install one bolt (1) in a recessed location to hold in position. Start the remaining five bolts (1) in recessed locations and tighten the bolts by hand.

    Tighten:  Torque the bolts to 12 N.m (108 lb in).

  2. Connect the internal wiring harness connector to the TFP switch.
  3. Install the oil pan and transmission internal oil filter. Refer to Oil Pan Replacement .
scientia non olet · About LEMON Manuals