LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Automatic Transmission - ALLISON - Introduction (2 Of 2)) >> Repair Instructions >> Oil Pressure Test Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install a new O-ring (1) on the pressure tap plug (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Installing Pressure Tap Plug
    GM1666654Courtesy of GENERAL MOTORS CORP.
  2. Install the plug and O-ring into the converter housing.

    Tighten:  Tighten the plug to 12 N.m (108 lb in).

scientia non olet · About LEMON Manuals