LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Automatic Transmission - ALLISON - Introduction (2 Of 2)) >> Repair Instructions >> Manual Detent Spring and Roller Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the detent spring assembly (2) onto the control valve assembly. Confirm that the roller of the detent spring assembly rests on the detent lever (1).
    Fig 1: Installing Detent Spring Assembly
    GM1633286Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install 2 detent spring bolts (3).

    Tighten:  Tighten the bolts to 12 N.m (108 lb in).

  3. Install the oil pan and transmission internal oil filter. Refer to Oil Pan Replacement .
scientia non olet · About LEMON Manuals