LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Automatic Transmission - ALLISON - Introduction (2 Of 2)) >> Repair Instructions >> Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the side heat shield (3).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    2. Fig 1: Installing Heat Shields
    GM744180Courtesy of GENERAL MOTORS CORP.
  2. Install the side heat shield bolt (4) and nut (5).

    Tighten: 

    • Tighten the bolt (4) to 17 N.m (13 lb ft).
    • Tighten the nut (5) to 25 N.m (18 lb ft).

  3. Install the front heat shield (1).
  4. Install the front heat shield bolts (2).

    Tighten:  Tighten the bolts (2) to 17 N.m (13 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals