LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Automatic Transmission - ALLISON - Introduction (2 Of 2)) >> Repair Instructions >> Control Valve Solenoid Replacement (SS1, SS2, SS3, TCC, and MAIN MOD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the oil pan and the transmission internal oil filter. Refer to Oil Pan Replacement .
  2. Disconnect the internal wiring harness from the solenoid being changed.
  3. Remove the solenoid retainer (2) for shift solenoid 1 (SS1) (5). Note the position of the solenoid connector and pull the solenoid (5) out of the bore in the control valve assembly (1). The O-rings (3 and 4) provide the resistance felt during removal.
    Fig 1: Locating Shift Solenoid 1
    GM1331386Courtesy of GENERAL MOTORS CORP.
  4. Remove the solenoid retainer (6) for shift solenoid 2 (SS2) (1) or shift solenoid 3 (SS3) (4), whichever is being replaced.
    Fig 2: Locating Shift Solenoid 2
    GM1633277Courtesy of GENERAL MOTORS CORP.
  5. Note the position of the solenoid connector and pull the solenoid out of the bore in the control valve assembly. The O-rings (2 and 3) provide the resistance felt during removal.
    6. IMPORTANT: The TCC pressure control solenoid (PCS) retaining bracket must not be modified. Note that the angle between the 2 bracket surfaces is less than 90 degrees. Replace the bracket if the angle is 90 degrees or more.
  6. Remove the TCC PCS retaining bolt and retaining bracket.
  7. Remove the TCC PCS (7).
scientia non olet · About LEMON Manuals