LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Automatic Transmission - ALLISON - Introduction (2 Of 2)) >> Repair Instructions >> Control Valve Body Assemble >> Shift Valve Body Assemble

Shift Valve Body Assemble

WARNING: This page is about a different variant/trim than selected.
    NOTE: Refer to Transmission Control Valve Body Overhaul Notice .
    Fig 1: Installing Solenoid Screen
    GM1581008Courtesy of GENERAL MOTORS CORP.
  1. Install the solenoid screen (1).

    Solenoid screen installed depth:  Ensure the solenoid screen (1) is installed to a depth of 0.50-1.00 mm (0.20-0.039 in) below the shift valve body surface, as shown in the insert, dimension A.

    2. Fig 2: Installing Spring And Control Main Valve
    GM795173Courtesy of GENERAL MOTORS CORP.
  2. Install control main valve (1) and spring (2).
    3. Fig 3: Compressing Control Main Valve Spring
    GM795171Courtesy of GENERAL MOTORS CORP.
  3. Using J 43773  (2), compress the valve spring. See Special Tools .
  4. Install retaining clip (1). Ensure the retaining clip (1) is below the valve body surface.
    5. Fig 4: Installing Plug, Spring, And Shift Valve 2
    GM795170Courtesy of GENERAL MOTORS CORP.
  5. Install shift valve 2 (1), spring (2), and plug (3).
    6. Fig 5: Compressing Shift Valve 2 Spring
    GM795169Courtesy of GENERAL MOTORS CORP.
  6. Using J 43773  (2), compress the valve spring. See Special Tools .
  7. Install retaining clip (1). Ensure the retaining clip is below the valve body surface.
    8. Fig 6: Installing Plug, Spring, And Shift Valve 3
    GM795166Courtesy of GENERAL MOTORS CORP.
  8. Install shift valve 3 (1), spring (2), and plug (3).
    9. Fig 7: Compressing The Shift Valve 3 Spring
    GM795164Courtesy of GENERAL MOTORS CORP.
  9. Using J 43773  (2), compress the valve spring. See Special Tools .
  10. Install retaining clip (1). Make sure the retaining clip is below the valve body surface.
    11. Fig 8: Installing Spring And Shift Valve 1
    GM795163Courtesy of GENERAL MOTORS CORP.
  11. Install shift valve 1 (1), spring (2), and plug.
    12. Fig 9: Compressing Shift Valve 1 Spring
    GM795162Courtesy of GENERAL MOTORS CORP.
  12. Using J 43773  (2), compress the valve spring. See Special Tools .
  13. Install retaining clip (1). Ensure the retaining clip is below the valve body surface.
scientia non olet · About LEMON Manuals