LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Transmission Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the transmission mount to the vehicle.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 1: Locating Transmission Mount Bolts
    GM702771Courtesy of GENERAL MOTORS CORP.
  2. Install the transmission mount to the transmission or transfer case adapter mounting bolts (1).

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  3. Lower the transmission.
  4. Install the transmission mount to the transmission support retaining nut or nuts.
    Fig 2: Identifying Transmission Mount Nuts
    GM647997Courtesy of GENERAL MOTORS CORP.

    Tighten:  Tighten the nut or nuts to 40 N.m (30 lb ft).

  5. Remove the transmission jack.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals