LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Transmission Fluid Cooler Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the transmission oil cooler lines to the vehicle.
    Fig 1: View Of Transmission Oil Cooler Lines
    GM396804Courtesy of GENERAL MOTORS CORP.
  2. Connect the cooling lines to the transmission. Refer to Transmission Fluid Cooler Line Quick Connect Fitting .
  3. Install the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  4. Lower the vehicle.
  5. Connect the transmission fluid cooler lines to the radiator. Refer to Transmission Fluid Cooler Line Quick Connect Fitting .
    Fig 2: Connecting Transmission Cooler Lines To Radiator
    GM1488801Courtesy of GENERAL MOTORS CORP.
  6. Connect the transmission fluid cooler hose to the Auxiliary oil cooler. Refer to Transmission Fluid Cooler Line Quick Connect Fitting .
    Fig 3: Installing Transmission Cooler Hoses To Cooler
    GM396817Courtesy of GENERAL MOTORS CORP.
  7. Install the front grille. Refer to Grille Replacement (GMC) or Grille Replacement (Chevrolet) in Exterior Trim.
scientia non olet · About LEMON Manuals