LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Transmission Fluid Auxiliary Cooler Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the auxiliary oil cooler to the vehicle.
    Fig 1: Installing Auxiliary Oil Cooler
    GM711677Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolts (1) and the push pins (2) that retain the auxiliary oil cooler to the radiator brace.

    Tighten:  Tighten the bolts to 12 N.m (9 lb ft).

  3. Connect the transmission oil cooler lines to the auxiliary cooler. Refer to Transmission Fluid Cooler Line Quick Connect Fitting .
  4. Install the front grill assembly. Refer to Grille Replacement (GMC) or Grille Replacement (Chevrolet) in Exterior Trim.
scientia non olet · About LEMON Manuals