LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Torque Converter Locator Bushing Replacement (5.3L Engine w/RPO HP2) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the starter/generator rotor. Refer to Starter/Generator Rotor Replacement (5.3L Engine w/RPO HP2) .
  2. Install the J 45849  (1) into the locator bushing (2).
    3. Fig 1: Using J 45849 To Remove Torque Converter Locator Bushing
    GM1277134Courtesy of GENERAL MOTORS CORP.
  3. Using 2 wrenches, rotate the inner shaft of J 45849  , in order to remove the bushing.
    4. Fig 2: Removing Locator Bushing
    GM1237554Courtesy of GENERAL MOTORS CORP.
  4. Remove the locator bushing.
scientia non olet · About LEMON Manuals