LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Torque Converter Locator Bushing Replacement (5.3L Engine w/RPO HP2) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the bushing into the end of the crankshaft.
    Fig 1: Positioning Torque Converter Locator Bushing
    GM1237554Courtesy of GENERAL MOTORS CORP.
  2. UsingJ 8433-1  (1) and J 45949  (2) install the locator bushing (3) into the rear of the crankshaft.
    Fig 2: Installing Locator Bushing Using J 8433-1 & J 45949 (RPO HP2)
    GM1277132Courtesy of GENERAL MOTORS CORP.
  3. Inspect the locator bushing for proper installation. A properly installed bushing should protrude no more than 8.4 mm (0.33 in) (a) from the rear of the crankshaft.
    Fig 3: Confirming Proper Locator Bushing Installation Position (RPO HP2)
    GM1277126Courtesy of GENERAL MOTORS CORP.
  4. Install the starter/generator rotor. Refer to Starter/Generator Rotor Replacement (5.3L Engine w/RPO HP2) .
scientia non olet · About LEMON Manuals