LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Control and Shift Solenoids Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission filter. Refer to Automatic Transmission Fluid/Filter Replacement .
  2. IMPORTANT: Removal of the 1-2 accumulator is necessary only if servicing the pressure control solenoid.
  3. Remove the 1-2 accumulator, if necessary. Refer to Accumulator Assembly, Spacer Plate, and Gaskets .
  4. Disconnect the internal wiring harness electrical connectors from the following components:
    Fig 1: Identifying Valve Body Electrical Connections
    GM181573Courtesy of GENERAL MOTORS CORP.
    • Transmission fluid pressure switch (1)
    • 1-2 shift control solenoid (2)
    • 2-3 shift control solenoid (3)
    • Pressure control solenoid (4)
    • torque converter clutch pulse width modulation (TCC PWM) solenoid (5)
    • 3-2 control solenoid (6)
  5. Fig 2: View Of Pressure Control Solenoid & Components
    GM1239566Courtesy of GENERAL MOTORS CORP.
  6. Remove the pressure control solenoid retainer bolt (364A) and retainer (378).
  7. Remove the pressure control solenoid (377).
  8. Fig 3: Removing 1-2 Shift Solenoid Retainer And 1-2 Shift Solenoid
    GM405071Courtesy of GENERAL MOTORS CORP.
  9. Remove the 1-2 shift solenoid retainer (395) and the 1-2 shift solenoid (267A).
  10. Fig 4: Removing 2-3 Shift Solenoid Retainer And 2-3 Shift Solenoid
    GM405074Courtesy of GENERAL MOTORS CORP.
  11. Remove the 2-3 shift solenoid retainer (395) and the 2-3 shift solenoid (367A).
  12. Fig 5: Removing 3-2 Control Solenoid Retainer And 3-2 Control Solenoid
    GM405083Courtesy of GENERAL MOTORS CORP.
  13. Remove the 3-2 control solenoid retainer (395) and the 3-2 control solenoid (394).