LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Automatic Transmission Range Selector Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Ensure that the transmission manual shaft lever is in the mechanical park position.
  2. Align and install the cable to the bracket.
  3. Install the range selector cable end (2) to the transmission range selector lever ball stud (1).
    Fig 1: View Of Range Selector Cable End At Transmission Range Selector Lever Ball Stud
    GM738167Courtesy of GENERAL MOTORS CORP.
  4. Install the cable clip on the transfer case, if equipped.
    5. Fig 2: View Of Retainer Securing Cable To Bracket
    GM858985Courtesy of GENERAL MOTORS CORP.
  5. Install the retainer that secures the cable to the bracket.
    6. Fig 3: Installing Clips On Cable To Floor Panel Reinforcement
    GM858969Courtesy of GENERAL MOTORS CORP.
  6. Install the clips on the cable to the floor panel reinforcement.
  7. Lower the vehicle.
    8. Fig 4: Installing Cable Grommet To Floor Panel
    GM858974Courtesy of GENERAL MOTORS CORP.
  8. Install the cable grommet to the floor panel.
    9. IMPORTANT: Avoid unnecessary twisting/bending of the range selector cable when installing the cable to the support.
    Fig 5: Installing Range Selector Cable To Support
    GM394466Courtesy of GENERAL MOTORS CORP.
  9. Install the range selector cable to the support.
    10. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 6: View Of Bolt Securing Selector Cable To Brace
    GM394467Courtesy of GENERAL MOTORS CORP.
  10. Install the bolt securing the cable support to the brace.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  11. Install the cable to the steering column bracket.
  12. Ensure the tangs fully seat (snap) into the steering column bracket.
  13. Install the cable end to the steering column ball stud.
    Fig 7: Installing Cable End To Steering Column Ball Stud
    GM858966Courtesy of GENERAL MOTORS CORP.
  14. Install the retainer securing the cable to the steering column.
    Fig 8: Installing Retainer Securing Cable To Steering Column
    GM858963Courtesy of GENERAL MOTORS CORP.
  15. Position the carpet and insulation around the driver's area.
  16. Install the driver's seat. Refer to Seat Replacement - Front Bucket in Seats.
  17. Install the instrument panel knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages, and Console.
  18. Test the transmission for proper shift operation.
  19. If all of the gear positions cannot be achieved, adjust the cable. Refer to Automatic Transmission Range Selector Cable Adjustment .
scientia non olet · About LEMON Manuals