LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Transfer Case - NVG 263-NP1 - Service & Diagnosis) >> Repair Instructions >> Transfer Case Shift Control Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Make sure that the transfer case control switch is seated properly in the instrument panel before installing the instrument panel trim bezel.
    Fig 1: Installing Selector Switch To Housing
    GM396838Courtesy of GENERAL MOTORS CORP.
  1. Install the transfer case driver control switch into the instrument panel.
  2. Install the IP cluster bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals