LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Transfer Case - NVG 246-NP8 - Service & Diagnosis) >> Repair Instructions >> Transfer Case Shift Control Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the instrument panel (I/P) cluster bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster in Instrument Panel, Gages, and Console.
  2. Using a flat-tipped screwdriver, gently pry the retaining clips open on the housing.
  3. Slide out the selector switch until the electrical connector are accessible.
  4. Disconnect the selector switch electrical connectors (2, 3).
    Fig 1: Disconnecting Selector Switch Electrical Connectors
    GM830158Courtesy of GENERAL MOTORS CORP.
  5. Remove the selector switch from the housing.
    Fig 2: Removing Selector Switch From Housing
    GM396838Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals