LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Transfer Case - NVG 246-NP8 - Service & Diagnosis) >> Repair Instructions >> Transfer Case Shift Control Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the selector switch close to the housing so the electrical connectors can be connected.
    Fig 1: Installing Selector Switch Into Housing
    GM396838Courtesy of GENERAL MOTORS CORP.
  2. Connect the selector switch electrical connectors (2, 3).
    Fig 2: Connecting Selector Switch Electrical Connectors
    GM830158Courtesy of GENERAL MOTORS CORP.
  3. Slide the selector switch into the housing until the switch snaps into place.
    IMPORTANT: Make sure that the selector switch is seated properly in the housing before installing the I/P cluster bezel.
  4. Install the I/P cluster bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals