LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Transfer Case - NVG 246-NP8 - Service & Diagnosis) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the J 43484  (2) to the J 8092  (1).
  2. Install the seal onto the J 43484  .
  3. Using the J 43484  (2) and the J 8092  (1), install the seal.
    Fig 1: Using J 8092 & J 43484 To Install Seal
    GM678236Courtesy of GENERAL MOTORS CORP.
  4. Install the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  5. Check the fluid level, add fluid if necessary.
  6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
scientia non olet · About LEMON Manuals