LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Transfer Case - NVG 246-NP8 - Service & Diagnosis) >> Repair Instructions >> Transfer Case Encoder Motor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transfer case shield. Refer to Transfer Case Shield Replacement .
  2. Remove the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  3. Disconnect the transfer case switch electrical connector (2).
    Fig 1: Identifying External Transfer Case Components
    GM829147Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the encoder motor electrical connector (7).
  5. Remove the encoder motor bolts.
  6. Remove the encoder motor.
    Fig 2: Removing Encoder Motor
    GM857301Courtesy of GENERAL MOTORS CORP.
  7. Remove the actuator insulator gasket.
  8. If replacing the encoder motor, remove the locating pins from the old motor.
scientia non olet · About LEMON Manuals