Test Description
WARNING: This page is about a different variant/trim than selected.
The number below refers to the step number on the diagnostic table.
- 2: This step replaces the transfer case shift control module.
DTC C0550
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Transfer Case Control Schematics Connector End View Reference: Transfer Case Control Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 | Replace the transfer case shift control module. Refer to Control Module References
for replacement, setup, and programming. Did you complete the repair? |
System OK | - |