Test Description
WARNING: This page is about a different variant/trim than selected.
The numbers below refer to the step numbers on the diagnostic table.
- 2: This step tests for proper reference voltage to the transfer case shift control module on the 4WD low circuit.
- 3: This step tests the 4WD low circuit for a short to voltage.
- 4: This step tests the 4WD low circuit for an open or high resistance.
- 5: This step repairs the 4WD low circuit for a short to voltage.
DTC C0359
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Transfer Case Control Schematics Connector End View Reference: Transfer Case Control Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
10-13.5 V | Go to Step 3 | Go to Step 4 |
| 3 |
|
0 V | Go to Step 7 | Go to Step 5 |
| 4 | Test the 4WD low circuit for an open, a high resistance, or a short to ground. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 8 | Go to Step 6 |
| 5 | Repair the 4WD low circuit for short to voltage. Refer to Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 8 | - |
| 6 | Replace the PCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the repair? |
- | Go to Step 8 | - |
| 7 | Replace the transfer case shift control module. Refer to Control Module References
for replacement, setup, and programming. Did you complete the repair? |
- | Go to Step 8 | - |
| 8 |
|
- | Go to Step 2 | System OK |