LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 8.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: Make sure the indicator tube does not come in contact with spark plug wires. Ensure that the spark plug wires are routed around the indicator tube.
    Fig 1: View Of Indicator Tube Bracket
    GM843863Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW O-ring seal onto the indicator tube.
  2. Install the indicator tube into the oil pan.
  3. Align the indicator tube bracket with the bolt hole in the block.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the indicator tube bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    5. Fig 2: View Of ECT Sensor Electrical Connector
    GM843867Courtesy of GENERAL MOTORS CORP.
  5. Install the ECT sensor connector to the indicator tube.
  6. Connect the ECT sensor electrical connector.
    7. Fig 3: View Of Oil Level Indicator & Tube
    GM843859Courtesy of GENERAL MOTORS CORP.
  7. Install the oil level indicator to the indicator tube.
scientia non olet · About LEMON Manuals