LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 8.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Sight Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the sight shield bracket to the studs (2), if necessary.
    Fig 1: Intake Manifold Sight Shield
    GM843779Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the sight shield bracket nuts (1), if necessary.

    Tighten:  Tighten the nuts to 5 N.m (44 lb in).

    3. NOTE: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.
  3. Install the intake manifold sight shield to the bracket.
  4. Snap the intake manifold sight shield onto the stud.
scientia non olet · About LEMON Manuals