LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 8.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement - Air Conditioning >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the A/C belt around the crankshaft balancer.
  2. Install the breaker bar into the A/C drive belt tensioner adapter opening
  3. Rotate the A/C belt tensioner clockwise in order to relieve tension on the tensioner.
    Fig 1: A/C Belt Tensioner
    GM370869Courtesy of GENERAL MOTORS CORP.
  4. Install the A/C belt over the idler pulley.
  5. Install the A/C belt around the A/C compressor pulley.
  6. Slowly release the tension on the A/C belt tensioner.
  7. Remove the breaker bar from the A/C belt tensioner.
  8. Inspect the A/C belt for proper installation and alignment.
  9. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals