LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 8.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement - Accessory >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Accessory Drive Belt 8.1L
    GM750183Courtesy of GENERAL MOTORS CORP.
  1. Install a breaker bar with hex-head socket to the drive belt tensioner bolt.
  2. Rotate the drive belt tensioner clockwise in order to relieve tension on the belt.
  3. Remove the belt from the pulleys and the drive belt tensioner.
  4. Slowly release the tension on the drive belt tensioner.
  5. Remove the breaker bar and socket and from the drive belt tensioner bolt.
  6. Clean and inspect the belt surfaces of all the pulleys.
scientia non olet · About LEMON Manuals