LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 8.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the drive belt idler pulley and bolt to the generator bracket.
    Fig 1: View Of Drive Belt Idler Pulley
    GM678804Courtesy of GENERAL MOTORS CORP.

    Snug the bolt finger tight.

    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .

    Tighten:  Tighten the drive belt idler pulley bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals