LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 8.1L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Pump Drive Installation

Oil Pump Drive Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Pump Drive
    GM470910Courtesy of GENERAL MOTORS CORP.
  1. Apply grease to the oil pump drive gear for ease of assembly.
    2. NOTE: Ensure both components are aligned correctly or serious engine damage will occur.
  2. Line up the oil pump drive gear with the oil pump drive shaft.
  3. Install the oil pump drive, making sure that the oil pump drive is fully seated in the engine block.
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the oil pump drive bolt.

    Tighten:  Tighten the oil pump drive bolt to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals