Engine Flywheel Installation (Automatic Transmission)
WARNING: This page is about a different variant/trim than selected.
- Install the engine flexplate.
- Install the engine flexplate bolts.
Tighten the fasteners following a criss-cross pattern.
Tighten:
- Tighten the engine flexplate bolts a first pass to 40 N.m (30 lb ft).
- Tighten the engine flexplate bolts a second pass to 80 N.m (59 lb ft).
- Tighten the engine flexplate bolts a final pass to 100 N.m (74 lb ft).
IMPORTANT:
Make sure the flexplate is installed correctly. Engine Side is stamped on the flexplate to assist with installation.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.