LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 8.1L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Cylinder Head Removal - Left

Cylinder Head Removal - Left

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Left Cylinder Head Bolts
    GM1309989Courtesy of GENERAL MOTORS CORP.
  1. Remove and discard the cylinder head bolts (227, 228, 229).
    2. Fig 2: View Of Left Cylinder Head And Alignment Pin
    GM470916Courtesy of GENERAL MOTORS CORP.
    NOTE: After removal, place the cylinder head on 2 wood blocks in order to prevent damage to the sealing surfaces.
  2. Remove the cylinder head.
    3. Fig 3: View Of Left Cylinder Head Gasket And Alignment Pins
    GM470974Courtesy of GENERAL MOTORS CORP.
  3. Remove the cylinder head gasket.
  4. Discard the cylinder head gasket.
scientia non olet · About LEMON Manuals