LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Turbocharger Vane Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Turbocharger Vane Position Sensor And Electrical Connector
    GM1334926Courtesy of GENERAL MOTORS CORP.
  1. Install the turbocharger vane position sensor to the turbocharger.

    Tighten:  Tighten the sensor to 28 N.m (21 lb ft).

  2. Install the turbocharger vane position sensor connector to the bracket.
  3. Connect the turbocharger vane position sensor electrical connector.
  4. Install the thermal reflective shield/tape, refer to the following procedure.
scientia non olet · About LEMON Manuals