LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: MAF/IAT Sensor Electrical Connector
    GM877698Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the mass air flow (MAF)/intake air temperature (IAT) sensor electrical connector (1).
  2. Remove the MAF/IAT sensor TORX® screws.
  3. Remove the MAF/IAT sensor.
    Fig 2: Removing MAF/IAT Sensor
    GM1606537Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals