LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the MAF/IAT sensor.
    Fig 1: Installing MAF/IAT Sensor
    GM1606537Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the MAF/IAT sensor TORX® screws.

    Tighten:  Tighten the screws to 8 N.m (70 lb in).

    3. Fig 2: MAF/IAT Sensor Electrical Connector
    GM877698Courtesy of GENERAL MOTORS CORP.
  3. Connect the MAF/IAT sensor electrical connector (1).
scientia non olet · About LEMON Manuals