LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Disconnecting MAP Sensor Electrical Connector
    GM1602064Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (2).
    2. Fig 2: Removing MAP Sensor
    GM1606538Courtesy of GENERAL MOTORS CORP.
  2. Remove the MAP sensor bolt.
  3. Remove the MAP sensor bracket and sensor.
scientia non olet · About LEMON Manuals