LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing MAP Sensor
    GM1606538Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor and bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the MAP sensor bolt.

    Tighten:  Tighten the MAP sensor to 10 N.m (89 lb in).

    3. Fig 2: Connecting MAP Sensor Electrical Connector
    GM1602064Courtesy of GENERAL MOTORS CORP.
  3. Connect the MAP sensor electrical connector (2).
scientia non olet · About LEMON Manuals